Fan Forced Suspended Unit Heater

• Description
• Accessories
• Related Items
• Reviews

Try this 10KW 480V 3P 5100 Series Unit Heater designed using 18 ga. steel cabinet with powder coated finish. This P3P5110CA1N model has spiral fin steel element with continuously brazed steel fins formed to allow side draw through air flow. It has Louvers that are individually adjustable for directional control of air flow.

Fan Forced Suspended Unit Heater - P3P5110CA1N Features:

CONSTRUCTION:

• 18 ga. steel cabinet with powder coated finish and control compartment housing a master terminal board with a hinged and latched access door, simplifying wiring, installation & maintenance

HEATING ELEMENT:

• Spiral fin steel element with continuously brazed steel fins formed to allow side draw through air flow

OVERHEAT PROTECTION:

• Automatic reset type limit

FAN and MOTOR:

• Totally enclosed, 1-speed, 1-phase, permanently lubricated, thermally protected motors with unit bearings on 3 KW - 20 KW models

LOUVER ASSEMBLY:

• Louvers are individually adjustable for directional control of air flow up to 15 deg from straight horizontal
• Optional diffusers available for down flow (vertical discharge) applications

TEMPERATURE CONTROLS:

• Optional low voltage and line voltage thermostats available with an adjustable temperature range of 50 deg -90 deg F
• Units with model numbers ending in CA1 are factory wired for low voltage controls

INSTALLATION:

• Unit Heaters can be mounted for horizontal or vertical discharge
• 5100 series suggested for applications up to 6000 feet; for applications up to or above 6000 feet see UH series.

FIELD INSTALLED OPTIONS:

• In-Built or wall mounted temperature control thermostats - low or line voltage
• Summer fan switch to operate the fan only.
• Power disconnect switch
• Heat stratification thermostat