• Description
• Accessories
• Related Items
• Reviews

Electric Forced Air Heaters - 7.5KW 5100 Series Horizontal/Vertical Discharge Fan Forced Suspended Unit Heater - TPI F2F5107CA1L - 25.6 BTU/Hr

7.5 KW 5100 Series Horizontal/Vertical Discharge Fan Forced Suspended Unit Heater is one of the best quality product by TPI , that assures long term investment and relief in winters. Model F2F5107CA1L has 18 ga. steel cabinet with powder coated finish. This unit comes with In-built or wall mounted temperature control thermostats - low or line voltage. Buy this multi featured unit NOW!

Fan Forced Suspended Unit Heater TPI F2F5107CA1L Features:

CONSTRUCTION:

• 18 ga. steel cabinet with powder coated finish and control compartment housing a master terminal board with a hinged and latched access door, simplifying wiring, installation & maintenance

HEATING ELEMENT:

• Spiral fin steel element with continuously brazed steel fins formed to allow side draw through air flow

OVERHEAT PROTECTION:

• 3.3 - 50 KW units come equipped with automatic reset type limit and 60 - 100 KW units come equipped with manual reset type limit to de-energize the heater should an over-temperature situation occur.

FAN and MOTOR:

• Totally enclosed, 1-speed, 1-phase, permanently lubricated, thermally protected motors with unit bearings on 3 KW - 20 KW models Totally enclosed, 2-speed, 1-phase, permanently lubricated, thermally protected motors with sleeve bearings on 25 KW - 50 KW models; 60 -100 KW have 1 speed motors, ball bearing, thermally protected.
• Fan over-ride purges unit of residual heat at shutdown

LOUVER ASSEMBLY:

• Louvers are individually adjustable for directional control of air flow up to 15 degree from straight horizontal
• Optional diffusers available for down flow (vertical discharge) applications

TEMPERATURE CONTROLS:

• Optional low voltage and line voltage thermostats available with an adjustable temperature range of 50 degree -90 degree F
• Units with model numbers ending in CA1 are factory wired for low voltage controls
• 25 KW through 50 KW units are designed for two stage heating operation, 60 - 70KW units designed for up to three stage and 80 - 100 KW units up to four stage

INSTALLATION:

• Unit Heaters can be mounted for horizontal or vertical discharge
• 5100 series suggested for applications up to 6000 feet; for applications up to or above 6000 feet see UH series.

FIELD INSTALLED OPTIONS:

• In-Built or wall mounted temperature control thermostats - low or line voltage
• Summer fan switch to operate the fan only.
• Power disconnect switch
• 60-100KW units can be multiple stage when used with optional SC5100 and C1025 stat
• Heat stratification thermostat